Belief 5KW air heater
Heat Power: (W) 5000 5kw
Rated Voltage: 12V/24V
Fuel Consumption: 0.19~0.66 l\h
Rated Power Consumption: 15~90 (W)
Working (Environment) Temperature: -40℃~+20℃
Working height above sea level: ≤1500m
Weight of Main Heater: (kg) 5.9
Dimensions :(mm) 425×148×162
All air heaters are tested , this includes fuel pump, control switch and heater. This is to ensure all our products are in 100% working order before delivery. All our products carry 12 months return to base warranty; in the event of a warranty claim we require the return of fuel pump, control switch and heater before we can process any claim.
IMPORTANT OPERATION INFORMATION
When the heater is used on HEAT output (2 green lights)
On low heat output for an extended period of time it must be turned up on high for 15 minutes to burn off the soot and carbon.
On the glow plug and burner cartridge, failure to do this will considerably shorten the cartridge’s life.
CARBON BUILDUP IS NOT COVERED BY WARRANTY
Heat output control and regulation on air heaters work in two ways
In this mode the heater will sense the cold air input coming into the heater and will turn itself up or down depending on the position of the control switch. If the switch is turned down to low this will cause the burner in the heater to go out. When the temperature drops below the control switch setting temperature, the burner will reignite and heating will resume. As the heater requires the glow plug to start the burner flame the glow plug ignition will draw around 10-12 amps (120w-144w) of current during start-up.
In this mode the positioning of the control switch regulates the heat output of the heater – basically the same as a bar radiator. Using this mode does not turn the burner off but turns down the fuel supply and fan speed with the heater only drawing a run current of between 1.5 amps to 2 amps (18w-30w).
Other heaters on the market use temperature control only; in some cases careful positioning of the control switch is required so that the heater does not turn off. If this is not achieved the heater will draw 12 amps on start up for approx 2 minutes before going to its run current – approx 2 amps (on high). This type of regulation is hard on batteries especially if only 1 battery is installed
Our belief heaters can be set on both temperature regulation or heat output; we recommend setting them on heat output as this gives better battery life and step-less heat output from low to high. This switching is achieved by pushing the up and down arrows at the same time on the control switch.
For more information and prices “click” the link below
We have many fuel tank options for caravans, motor homes and portable heaters. Our fitting (labour cost) does not include fuel tank supply as every install is different and depends on customers’ requirements.
We can also supply duct guarding custom installation if required.
PLEASE BE WARY OF THESE TANKS – THEY ARE POOR QUALITY AND LEAK FUEL, AND THE CAPS DO NOT SEAL:
NEW TANKS SUPPLIED IN OUR KITS WITH PUMP, FUEL FILTER AND SILENT MOUNTS ALREADY FITTED
5L WITH SPLASH BOX